HOME HELP FEEDBACK SUBSCRIPTIONS ARCHIVE SEARCH TABLE OF CONTENTS		QUICK SEARCH:   [advanced] Author: Keyword(s): Year:  Vol:  Page:

This Article Figures Only Full Text Free Full Text (PDF) Free Alert me when this article is cited Alert me if a correction is posted Services Similar articles in this journal Similar articles in ISI Web of Science Similar articles in PubMed Alert me to new issues of the journal Download to citation manager Citing Articles Citing Articles via HighWire Citing Articles via ISI Web of Science (7) Citing Articles via Google Scholar Google Scholar Articles by Sukkariyah, B. F. Articles by Chaney, R. L. Search for Related Content PubMed PubMed Citation Articles by Sukkariyah, B. F. Articles by Chaney, R. L. Agricola Articles by Sukkariyah, B. F. Articles by Chaney, R. L. Related Collections Municipal Waste Heavy Metals

TECHNICAL REPORTS

Heavy Metals in the Environment

Recovery and Distribution of Biosolids-Derived Trace Metals in a Clay Loam Soil

^a Department of Crop and Soil Environmental Sciences, Virginia Polytechnic Institute and State University, Blacksburg, VA 24060
^b USDA-ARS, Beltsville, MD 20705

^* Corresponding author (bsukkari{at}vt.edu)

Received for publication May 10, 2004. The long-term mobility of trace metals has been cited as a potential hazard by critics of EPA 503 rule governing the land application of biosolids. The objectives of this study were to assess the accumulation of Cu, Ni, Cd, and Zn within the soil profile; the distribution of exchangeable, specifically adsorbed, organic, and oxide fractions of each metal; and mass balance of Cu, Ni, and Zn 17 yr after a single biosolids application. Biosolids were applied to 1.5- x 2.3-m confined plots of a Davidson clay loam (fine, kaolinitic, thermic Rhodic Kandiudult) in 1984 at 0, 42, 84, 126, 168, and 210 Mg ha^–1. The highest biosolids application supplied 4.5, 750, 43, and 600 kg ha^–1 of Cd, Cu, Ni, and Zn, respectively. Soils were sampled to a depth of 0.9 m and sectioned into 5-cm increments after separating the Ap horizon. Total (EPA-3050B), bioavailable (Mehlich-I), sequential extraction, and dispersible clay analyses were performed on samples from the control, 126 Mg ha^–1, and 210 Mg ha^–1 treatments. Trace metals are still concentrated in the top 0.2 m with slight enrichment down to 0.3 m. More than 85% of applied Cu, Ni, and Zn are still found in the topsoil where biosolids was incorporated and 95% or more of the applied metals were accounted for with mass balance calculations. Mehlich-I results showed a slight increase in metal concentration down to 0.35 m. Biosolids application increased the concentrations of trace metals in all the extracted fractions. The major portions of Cu, Zn, and Ni are associated with the metal-oxides fraction. Dispersible clay content and water-soluble metal contents were low and except for water-soluble Zn they were not affected by biosolids application. Results from this study showed that 17 yr after biosolids application there was negligible movement of trace metals through the soil profile and consequently there is little risk of contamination of ground water at this site.

Abbreviations: EPA-3050B, method used to determine total metal concentration

This article has been cited by other articles:

				B. Sukkariyah, G. Evanylo, and L. Zelazny Distribution of Copper, Zinc, and Phosphorus in Coastal Plain Soils Receiving Repeated Liquid Biosolids Applications J. Environ. Qual., November 1, 2007; 36(6): 1618 - 1626. [Abstract] [Full Text] [PDF]

				K. A. Barbarick and J. A. Ippolito Nutrient Assessment of a Dryland Wheat Agroecosystem after 12 Years of Biosolids Applications Agron. J., April 4, 2007; 99(3): 715 - 722. [Abstract] [Full Text] [PDF]

				B. F. Sukkariyah, G. Evanylo, L. Zelazny, and R. L. Chaney Cadmium, Copper, Nickel, and Zinc Availability in a Biosolids-Amended Piedmont Soil Years after Application J. Environ. Qual., November 7, 2005; 34(6): 2255 - 2262. [Abstract] [Full Text] [PDF]